Ethernet Controller TCW112-WD Teracom

Il TCW112-WD è un ethernet controller della Teracom progettato per funzionare sulle reti IP. Ha un ingresso digitale e uno analogico, un’interfaccia 1-Wire e un’uscita a relè. Può essere gestito tramite un’interfaccia web che attraverso programmi SNMP. Il relè può essere attivato sia da remoto (web, SNMP ecc.) che in locale, in base alla presenza/assenza di un ping echo request o echo replay).

Per ogni parametro monitorato (temperatura, umidità, voltaggio analogico, contatti liberi da tensione) può essere spedito un trap SNMP che segnali eventuali uscite dal range predefinito.

snmp-ethernet-controller-tcw112wd

 

Ethernet Controller TCW112-WD: Specifiche Tecniche

  • 10 Mb Ethernet connectivity;
  • Password protected, web based configuration and control;
  • 1 digital input with ” dry contact” and “logic level” modes;
  • 1 analog input with 0 to 60VDC range;
  • 1 relay with NO and NC contacts;
  • Long 1-Wire support for 1 temperature (TST1XX) or temperature/humidity (TSH2xx) sensor;
  • SNMP v.1 support;
  • SNMP traps sending for alert conditions;
  • VLAN support;
  • MAC address filtering;
  • Remote FTP firmware update.

Ethernet Controller TCW112-WD: Applicazioni tipiche

  • IP watchdog for ISP networks;
  • Environmental monitoring of server rooms;
  • Control and management of ISP networks;
  • Remote control of electric devices.

Ethernet Controller TCW112-WD: Parametri tecnici

  • Supply voltage, VDC: 12 ± 2
  • Maximum current consumption ( with activated relay), mA: 120
  • Weight g: 45
  • Dimensions, mm: 72 x 50 x 18
  • Operating temperature, °C: 0 to +40
  • Maximum humidity in 0 to 31°C range, %RH: 80
  • Maximum humidity at 40°C (linear slope between 31-40°C), %RH: 50
  • Minimum high level input voltage for digital inputs, VDC: +2.5
  • Maximum low level input voltage for digital inputs, VDC: +0.8
  • Maximum input voltage for digital inputs, VDC: +5.5
  • Analog input range, VDC: 0 to +60
  • Supply voltage for 1-wire bus (+VW), VDC: 5.3 ± 0.2
  • Maximum output current for 1-wire bus (+VW), A: 0.2
  • Supply voltage for analog sensor (+VA), VDC: 5.0 ± 0.1
  • Maximum output current for analog sensor (+VA), A: 0.1
  • Maximum switchable current for relay contacts, А: 3
  • Maximum switchable voltage for relay contacts, VAC/VDC: 30/24

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.